April 30, 2020
The owners of 648.3 MW of peak power generation capacity in an around New York City have elected to retire the natural gas and oil-fired units to comply with stricter air emissions regulations, while approximately 1,300 MW will be retrofitted with pollution-control equipment according to an April 8, 2020 report from S&P Market Intelligence.
S&P Global Platts reviewed the compliance plans submitted to the New York State Department of Environmental Conservation totaling 5,482 MW of peaking capacity. The filings were obtained through a Freedom of Information Act Request.
The regulations are officially known as Subpart 227-3, Ozone Season Oxides of Nitrogen (NOx) Emission Limits for Simple Cycle and Regenerative Combustion Turbines.
Power market participants have been anticipating the results of the compliance filings in order to determine how much generation capacity could retire as a result of the rules.
“The elections to retire or retrofit within New York City come as little surprise, as the age of many of these facilities is telling in their decision to retire or to continue to invest,” Kieran Kemmerer, power market analyst with S&P Global Platts Analytics, said in an email.
“That being said, with a sizeable amount of oil-fired capacity retiring, a severe winter could pose challenges, particularly with the known gas deliverability issues to the NYC region, and as a result put upward pressure on power prices,” Kemmerer said.
In addition to supporting the power grid in the New York City region during extremely cold weather, peaking capacity could be needed if renewable energy capacity increases in that area.
“Significant amounts of peaking capacity must be retained to compensate for the growing proportion of intermittent renewable sources,” Matthew Cordaro, a former Midcontinent Independent System Operator CEO who now resides in New York, said in an email.
“This will be necessary no matter how the pace of adding clean energy facilities may slow because of things like the coronavirus and permitting hurdles or an acceleration in the retirement of traditional steam units,” Cordaro said.
BLACKSTART RESOURCES
Several generation units totaling 86 MW of nameplate capacity will be reclassified as “blackstart only” by 2023 and 2025, the dates when the stricter emissions limits go into effect. Blackstart resources are generating units and associated equipment which have the ability to be started without support from the power grid. They are used to restart the system after a power failure.
“Fortunately, over the years many combustion turbines were modified to meet more stringent emission controls. Those that have not can continue to operate as blackstart generators under the new air pollution requirements,” Cordaro said.
Approximately 1,600 MW of capacity will be able to meet the tighter emissions limits using existing pollution controls, according to the filings. The Astoria Generating Company, a subsidiary of Eastern Generation, owns a large share of the pre-1990 peaking units covered by the regulations.
Astoria Generating Company’s current plan to comply with the new requirements is to stop burning oil during the summer in 2023 and to stop burning natural gas during the summer in 2025 at the company’s facilities in Brooklyn and Queens, said John Reese, senior vice president of Eastern Generation Company.
That could mean having roughly 900 MW less capacity in the summer in addition to the 650 MW that will have retired, which could result in reduced capacity in summer 2023 of about 1,550 MW. As an alternative, Astoria Generating is considering installing pollution controls which may or may not be economically or logistically feasible and the company has proposed a repowering of its Gowanus facility and a retirement of its Narrows facility, Reese said.
“These retirements also coincide with the implementation of Carbon Pricing in NYISO, which poses substantial upside to power prices in Zones J and K,” Platts’ Kemmerer said.
“We anticipate battery storage will help replace some of this peaking capacity, given New York’s procurements and targets, but will have little impact on prices at the outset with low concentrations of storage/renewables downstate,” he said.
The information contained in the compliance plans will also be a key input into the New York Independent System Operator’s Reliability Needs Assessment that determines how much power generation is required, and where on the system it is needed to maintain reliability.
The final rule includes a provision that allows the NYISO to designate units to continue to operate on a temporary basis if needed to maintain electric system reliability while a permanent solution is implemented.
What this means to you
Owners of 648.3 MW of peak power generation capacity in an around New York City have elected to retire the natural gas and oil-fired units to comply with stricter air emissions regulations, while approximately 1,300 MW will be retrofitted with pollution-control equipment.
MIRATECH can help
Contact MIRATECH for emission control solutions for power generation stationary engines.